Vertical Level switch plastic material
1/8" BSP connection
PP or PVDF material
SPST or SPDT contacts
USE:
Made to ensure, with maximum safety, the minimum or maximum level of liquids in tanks and hydraulic power packs containing mineral oils with viscosity not higher than 80°E.
OPERATION:
When the float of the indicator encounters the Reed switch at the pre-established point, the contact activated by the magnet housed in the float opens or closes, thus obtaining the possibility of sending a luminous or acoustic signal or activating or disconnecting any electrical equipment connected to it.
FITTING:
The indicator must be fitted in the vertical position, and the float must be at least 30mm from ferrous surfaces (walls, tanks, etc.).
It can be placed directly in the cover or on the bottom of the tank, to control the minimum or maximum level.
Also, connected by means of a pipe acting as an extension, it can be used to control a point at the required height.
IMPORTANT:
To invert the contact from N.C. to N.O. just remove the bottom stop and turn the float upside down.
Contact us to request advice from one of our technicians
Contact us